-54-
Model G0819 (Mfd. Since 09/16)
Changing V-Belts
Check the V-belts periodically for signs of glaz-
ing, cracking, fraying, oil/grease on belts, or any
other evidence of damage or wear. If any of these
conditions are present, replace both of the V-belts
as a matched set.
Tools Needed
Qty
Screwdriver Phillips #2 ...................................... 1
Open-End Wrench 19mm .................................. 1
To change V-belts:
1. DISCONNECT MACHINE FROM POWER!
2. Open upper right access door and remove
lower right access panel.
3. Remove V-belt cover located inside upper
right access door (see
Figures 86–87).
Figure 86. Location of V-belt cover.
Belt Cover
x 2
Figure 87. V-belt cover removed to expose
V-belts and sanding drum pulley.
Sanding Drum
Pulley
V-Belts
4. Loosen V-belt tension jam nut several turns
(see
Figure 88) to allow main motor to raise
as much as possible.
5. Rotate V-belt tension adjustment nut to raise
or lower main motor (see
Figure 88) until
V-belts are loose enough to be removed from
main motor pulley.
Figure 88. V-belt removal/installation
components.
6. Remove V-belts from main motor pulley (see
Figure 88), then remove V-belts from sand-
ing drum pulley (see
Figure 87).
7. Place a new matching pair of V-belts onto
sanding drum pulley (see
Figure 87), and
then loop other end of V-belts around main
motor pulley (see
Figure 88).
8. Properly tension V-belts (refer to Checking/
Adjusting V-Belt Tension on Page 53 for
more information).
9. Re-install V-belt cover from Step 3, close and
secure upper right access door, and re-install
lower right access panel.
Adjustment
Nut
Jam Nut
Main Motor
V-Belts
Summary of Contents for G0819
Page 84: ......
