Model G0819 (Mfd. Since 09/16)
-37-
SECTION 6: MAINTENANCE
To reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.
Cleaning &
Protecting
For optimum performance from your machine,
follow this maintenance schedule and refer to any
specific instructions given in this section.
Before Daily Check:
•
Check/tighten loose mounting bolts.
•
Check/replace worn/damaged sanding belts.
•
Check for worn or damaged wires.
•
Check safety features.
•
Check for any unsafe condition.
•
Check condition of platen graphite pad.
Weekly Maintenance:
•
Drain water in air filter water trap (
Page 39).
•
Lubricate grease fittings on conveyor belt
roller axles and sanding belt axles (
Page 38).
Monthly Check:
•
V-belt tension, damage, or wear.
•
Clean/vacuum dust buildup from inside cabi-
net and off motor.
•
Grease table elevation chain, leadscrews,
and sprockets
(Page 38).
•
Grease feed chain and sprockets (
Page 39).
Yearly Check:
•
Replace white moisture filters on air regulator.
Cleaning the Model G0819 is relatively easy.
Vacuum excess wood chips and sawdust, and
wipe off the remaining dust with a dry cloth. If any
resin has built up, use a resin-dissolving cleaner
to remove it.
It is essential to clean the components before
lubricating them, because dust and chips build up
on lubricated components and make the compo-
nents hard to move. Simply adding more grease
to the components with built-up grime on them will
not yield smooth moving components.
Clean the components in this section with mineral
spirits.
All other bearings are internally lubricated and
sealed at the factory. Simply leave them alone
unless they need to be replaced.
The following are the main components that
need to be lubricated:
•
Grease Fittings
•
Table Elevation Leadscrews
•
Table Elevation Chain and Sprockets
•
Feed Motor Chain and Sprockets
Schedules are based on average use. Adjust
lubrication according to your level of use.
Lubrication
Schedule
Summary of Contents for G0819
Page 84: ......
