Model G0787 (Mfd. Since 09/14)
-13-
5. Insert threaded end of table lock knob through
slot in work table and into threaded hole in
sander body.
6. Set work table at desired angle and tighten
table lock knob.
4. Insert work table index pin into upper hole on
sander base (see
Figure 9).
1. Attach sandpaper disc to aluminum disc (see
Attaching Sandpaper Disc on Page 21).
2. Mount disc cover to holes in sander body
near bottom of aluminum disc, using (2) M4 x
10 tap screws, as shown in
Figure 8.
3. Install 6mm fender washer on table lock
knob, as shown in
Figure 9.
Figure 9. Installing work table.
Table Lock
Knob & Washer
Upper Hole
Index Pin
Threaded Hole
Figure 8. Installing disc cover.
x 2
Disc Cover
Assembly
The Model G0787 ships with the sanding belt
pre-installed.
7. Insert (2) M8-1.25 x 16 cap screws with (2)
8mm flat washers through slot in backstop
and thread into mounting holes in sander
body (see
Figure 10).
Note: Do not fully tighten cap screws yet.
Figure 10. Backstop mounting location.
x 2
8. Use a square to position backstop per-
pendicular to sanding belt, with a gap of
approximately
1
⁄
8
" between backstop and belt,
then tighten cap screws from
Step 1 (see
Figure 11).
Figure 11. Squaring backstop.
1
⁄
8
" Gap
Backstop
Summary of Contents for G0787
Page 40: ......
