Grizzly G0787, Owner'S Manual

Page: 22 / 40

-20-
Model G0787 (Mfd. Since 09/14)
Vertical Sanding
Vertical sanding is best performed with the work
table attached to the sanding bed, for operations
similar to disc sanding. With more surface area
than the sanding disc, the sanding belt can sand
more aggressively.
5. Insert index pin of work table into mounting
hole in sanding bed (see Figure 22).
6. Insert table lock knob with washer through
slot in work table, and into threaded hole in
sander body (see
Figure 22).
7. Set desired work table angle (see Setting
Work Table Angle on Page 17), and tighten
table lock knob.
Figure 22. Installing work table on sanding bed.
Index Pin
Slot
Threaded
Hole
Lock Knob
& Washer
To mount work table to sanding bed:
1. DISCONNECT MACHINE FROM POWER!
2. Loosen and remove (2) M8-1.25 x 16 cap
screws, (2) 8mm flat washers, and backstop
(see
Figure 21).
3. Loosen work table lock knob (Figure 21) and
remove lock knob, washer, and work table
from sanding disc.
Figure 21. Backstop removal.
Backstop
4. Adjust sanding bed to vertical position (see
Adjusting Sanding Bed Angle on Page 18.
Work Table
Lock Knob
x 2