Model G0787 (Mfd. Since 09/14)
-3-
Controls &
Components
Refer to
Figures 1–2 and the following descrip-
tions to become familiar with the basic controls of
this machine.
To reduce your risk of
serious injury, read this
entire manual BEFORE
using machine.
Figure 2. Work table and miter gauge controls,
sanding bed, and dust port.
G. Angle Scale: Indicates angle of work table
relative to sanding disc from 90 – 45°.
H. Sanding Bed: The surface around which the
sanding belt rotates; tilts from 0 – 90°.
I. Miter Gauge: Used for miter sanding.
Adjustable from 60° left – 60° right.
J. Work Table: Supports workpiece during
angle, miter, and compound miter sanding.
T-slot functions as a guide for miter gauge.
K. Angle Adjustment Knob: Tightens to secure
work table at desired angle.
L. 2
1
⁄
2
" Dust Port: Connects to dust collection
system (not included).
A. Belt Tensioning Lever: When pressed in,
provides tension to sanding belt during use.
When pulled out, releases tension for chang-
ing/replacing belt.
B. Backstop: Prevents workpiece from being
thrown by rotation of sanding belt.
C. Sanding Belt: Used for sanding with grain
along length of workpiece, and for sanding
inside curves.
D. Tracking Control Knob: Used to adjust
alignment of sanding belt to sanding bed.
E. ON/OFF Switch: Turns motor ON and OFF.
Remove yellow tab to lock in
OFF position.
F. Sanding Disc: Used for performing angle
and miter sanding operations on work table.
Figure 1. Sanding belt and controls, sanding
disc, and ON/OFF switch.
A
B
C
D
E
F
G
L
K
J
I
H
Summary of Contents for G0787
Page 40: ......
