Griesser SoloTel 2, Manual

Page: 3 / 11

© elero GmbH 4 | EN © elero GmbH EN | 5
which are fi tted with elero-radio receivers. Other use, or use beyond
this is not considered to be use for intended purpose.
The handheld transmitter is referred to as "device" in this manual.
Exclusion of liability
elero GmbH assumes no liability for personal injuries, property
damage and
fi nancial losses which arise from use other than
mentioned above, modi fi cations to the device, improper use and
failure to observe the operating instructions. Liability for material
defects is excluded in such cases.
Scope of supply
SoloTel 2 (battery included in the device), wall bracket, 2 wall plugs,
2 screws.
Technical Data
Name of device SoloTel 2
Operating voltage 3 V DC
Battery type 1 x CR 2032
IP Code IP 20
Temperature range 0 to +55 °C
Radio frequency 868 MHz frequency band
Dimensions in mm (wall bracket) L 85 x W 85 x H 18
Weight in grams (including.
batteries). 45
There are different device names for the USA, Canada, Australia
and some countries in South America.
Radio frequency 915 MHz frequency band
Operation
• Use only in dry rooms.
• If one or more transmitters are used for controlling the system, its
operating range must stay visible during operation.
• Keep control systems out of the reach of children and the
disabled.
• Dispose of used batteries properly.
Safety instructions for radio operation
Observe all safety instructions for radio operation.
Only use radio systems which are approved and can be operated
without interference.
• Radio systems must not be operated in areas where there is an
increased risk of interference (e.g. hospitals, airports).
• The remote control is only approved for devices and systems for
which any malfunction of the transmitter or receiver would not
result in a risk for persons, animals or property, or if such a risk is
covered by other safety equipment.
• The operator has no protection whatsoever against interference
by other telecommunication installations and local terminals (e.g.
also from radio installations which are operated properly in the
same frequency range).
• The range of the radio signal is limited by legislation and the
structural conditions.
Intended use
The SoloTel 2 is a single-channel transmitter. It can be used
unidirectionally (compatible with the existing ProLine program) or
bidirectionally. The handheld transmitter should only be used for
controlling roller shutter, Venetian blinds and sun protection systems
Safety instructions for radio operation Exclusion of liability