Griesser SoloTel 2, Manual

Page: 9 / 11

© elero GmbH 16 | EN © elero GmbH EN | 17
Fault Cause Remedy
Drive does not run,
status display lights
red or
fl ashes orange
Unidirectional: Status
display lights green
1. The receiver is
outside the sending
range.
2. Receiver out of
order or defective
3. Receiver not yet
programmed 1. Reduce distance to
the receiver
2. Switch on or ex-
change receiver
3. Program receiver
Drive operates in he
wrong direction Directions are incor-
rectly allocated Delete transmitter and
reprogram
Repair
Please contact your dealer if you have any questions.
Please always provide the following information:
• Item number and name on the type plate
• Type of fault
• Previously occurring unusual events
• Accompanying conditions
• Own presumption
The channel in the transmitter is also deleted.
In unidirectional radio operation, the status display lights for 6
seconds:
fi rst green brie fl y twice and then red.
Battery Replacement
Note
Replace batteries only with batteries of the
identical type.
1. Unscrew the screws on the rear side of the
device and open the casing.
2. Remove the battery.
3. Insert the new battery in the correct
position.
4. Put the device back together again.
Dispose of used batteries properly.
Cleaning
Clean the device with a damp cloth. Do not use a detergent. This
may attack the plastic.
Disposal
After the end of its service life, dispose of the device in accordance
with the applicable regulations.
Troubleshooting
Fault Cause Remedy
Drive does not run,
status display does
not light 1. Batteries are low
2. Batteries are incor-
rectly installed 1. Insert new batteries
2. Insert batteries
correctly
Repair