Griesser SoloTel 2, Manual

Page: 6 / 11

© elero GmbH 10 | EN © elero GmbH EN | 11
If more than 10 bidirectional receivers are being programmed in the
channel at the same time, the transmitter channel in programming
mode switches to group mode. The group mode is indicated by fast
fl ashing with pauses.
Programming in group mode is completed after a 2-minute pause or
pressing the
STOP button for 6 seconds.
Note
A jogging mode for Venetian blinds for quickly reaching
receivers which are further away is not possible in a transmitter
channel with more than 10 programmed receivers.
Synchronous Programming Mode
For programming additional receivers to one transmitter at the same
time:
1. Press the
DOWN buttons and the programming button P (back
of device) simultaneously (for 3 seconds) on a transmitter which
has already been programmed to the receivers). The status
display
fl ashes. The receivers are now in programming mode.
2. For bidirectional operation only: press the programming button
P on the transmitter to be programmed until the status display
lights brie fl y. The receivers are now in programming mode (up/
down movements).
3. Press the OPEN button as soon as the blind starts moving in
Open direction (within 1 second at the most). The status display
lights brie
fl y. The blinds stop brie fl y, start moving again, stop and
then move downwards.
4. Immediately (within maximum 1 second) after starting down
travel, press the DOWN button. The status display lights brie fl y.
The blinds stop moving. The transmitter channel is programmed.
Programming additional transmitters
Note
If several receivers are connected to the same feed line,
then all are simultaneously in programming mode for approx.
5 minutes after switching on the mains power.
If the
P button on the transmitter is now pressed, all the
receivers start programming mode at the same time (up/down
movements). Randomly different intervals between open /
down movements cause the receivers to become offset against
one another. The longer programming is delayed, the greater
the offset will be.
The short up/down movements can be stopped by pressing
the
STOP button brie fl y on a transmitter which has already
been programmed. The programming mode in the receiver is
interrupted.
The transmitter can now be assigned without having to
disconnect individual receivers. If the blind moves in the wrong
direction, delete the transmitter and program it again.
(
→
see Deletion of transmitter)
For programming additional transmitters to one receiver:
1. Press the
UP , DOWN buttons and the programming button P
(back of device) simultaneously (for 3 seconds) on a transmitter
which has already been programmed to the receiver. The
status display lights brie
fl y. The receiver is now in programming
mode. Press the programming button P on the transmitter to be
programmed until the status display lights brie fl y. The receiver is
now in programming mode (up/down movements).
2. Press the OPEN button as soon as the blind starts moving in
Open direction (within 1 second at the most). The status display
lights brie
fl y. The blind stops brie fl y, starts moving again and
then moves downwards.
3. Immediately (within maximum 1 second) after starting down
travel, press the DOWN button. The status display lights brie fl y.
The blind stops. The transmitter channel is programmed.
Explanation of functions Explanation of functions