Griesser SoloTel 2, Manual

Page: 8 / 11

© elero GmbH 14 | EN © elero GmbH EN | 15
The pulse time can be changed by the user. Keep the STOP and
UP buttons on a programmed transmitter pressed for 6 seconds
for this. The drive starts to move in small pulses. As soon as the
blind has travelled the required distance, release the
UP button,
then release the STOP button. The new pulse time is saved. The
new pulse time corresponds to the sum of all pulse times during
the programming of the pulse time. The Combio JA Pulse ends the
programming of the pulse time after 30 pulses.
Deleting positions/deleting transmitters
Deleting intermediate position in the receiver
1. Press both the STOP and DOWN buttons.
2. Hold down this button combination for approx. 3 seconds.
The status display lights brie fl y.
Deleting the ventilation position from the receiver
1. Press both the STOP button and the OPEN button.
2. Hold down this button combination for approx. 3 seconds.
The status display lights brie fl y.
Deleting the transmitter channel in the receiver
1. Press both the STOP button and the programming button P (on
the back of the device).
2. Keep this button combination pressed for approx. 6 seconds
until the status display lights orange brie fl y and then lights red.
In unidirectional radio operation, the status display lights for
6 seconds:
fi rst green brie fl y twice and then red.
The channel in the transmitter is also deleted.
Deleting all the transmitters in the receiver
1. Press the STOP button and also the programming button P (on
the back of the device) + OPEN DOWN button.
2. Hold down this button combination for approx. 6 seconds.
The status display lights orange brie fl y twice, followed by red
(bidirectional).
2. Also press the STOP - button. The blind will stop. The status
display lights brie fl y.
The ventilation position/tilting position is programmed.
Approaching intermediate position
Requirement
The transmitter/transmitter channel is programmed. The blind is at
its upper end position.
1. Press the DOWN button twice brie fl y. The status display lights
brie fl y.
2. The blind travels to the stored intermediate position. In the case
of Venetian blinds, the slats turn automatically after reaching the
intermediate position if a tilting position has been programmed. If
no intermediate position has been programmed, the blind moves
to the bottom end position (not when using Combio JA Pulse).
Approaching ventilation/tilting position
Requirement
The transmitter/transmitter channel is programmed. The blind is at
its lower end position.
1. Press the OPEN button twice brie fl y. The status display lights
brie fl y.
2. The blind travels to the stored ventilation / tilting position. If no
ventilation/tilting position has been programmed, the blind moves
to the top end position (not when using Combio JA Pulse).
Operation of the transmitter using Combio JA
Pulse
A Combio 868/915 JA Pulse can be used for the precise adjustment
of the slats for Venetian blind drives.
The preset pulse time of Combio Pulse is cycled by pressing the
UP
or DOWN button.
Explanation of functions Explanation of functions