Griesser SoloTel 2, Manual

Page: 5 / 11

© elero GmbH 8 | EN © elero GmbH EN | 9
Group control unit
A group is understood to mean the control of several receivers
at the same time. The selected group is controlled by a travel
command.
Any number of receivers can be programmed and controlled in the
channel.
Programming the transmitter
Requirement
The receiver is installed. Check whether the channel is deleted or
in the correct mode according to the status display.
Stand in front of the blind to be programmed for the programming.
1. With electrical receivers which have already been installed,
switch the fuse off, and on again a few seconds later.
The receiver is now in programming mode for about 5 minutes.
2. Press the programming button P on the back of the device brie fl y
(approx. 1 second) until the status display lights for a short time.
The blind moves up and down for approx. two minutes, showing
that the receiver is in programming mode.
3. Press the OPEN button as soon as the blind starts moving in
Open direction (within 1 second at the most). The status display
lights brie
fl y.
The blind stops brie fl y, starts moving again, stops and then
moves in the Down direction.
4. Immediately (within maximum 1 second) after starting down
travel, press the DOWN button. The status display lights brie fl y.
The blind stops. The transmitter channel is programmed.
Note
If the blind does not stop, it must be programmed again.
A bidirectional programming process in the handheld
transmitter can be cancelled by pressing the STOP button for
6 seconds.
Note
Do not press the P button until the receivers are in
programming mode. The channel for a radio system is
decided during the programming. If the receivers are not in
programming mode, the channel of the sender changes to the
unidirectional mode. In order to restore the starting condition,
press the
STOP and P- buttons simultaneously for 6 seconds
until the status display lights.
Status display
A radio signal is indicated by the illumination of the status display
(LED above the buttons). The different colours of the status display
mean:
Status display Meaning
Flashing orange Channel (transmitter) not programmed in any
receiver
Quick fl ashing
orange
Channel (transmitter) in bidirectional program-
ming mode. Operation of already programmed
receivers not possible.
Every 3 seconds in group programming mode
(also without pressing a button)
Orange Channel (transmitter) is operating bidirection-
ally: Transmit signal is being sent
Green Channel (transmitter) is operating unidirection-
ally: Transmit signal is being sent
Orange or green
fl ashes several times
then red
Channel (transmitter) is deleted
Flashing red Batteries weak
The transmitting power or the radio range will be reduced by
the reduction in the performance of the battery. If the voltage
drops below 2 V, functions are no longer executed and nothing is
displayed.
Explanation of functions Explanation of functions