Griesser 179086, Operating Instructions Manual

Page: 21 / 24

38 | EN
EN | 39
4.6.5 Programming the intermediate position
in the receiver
Requirement
The transmitter is now programmed.
The end positions of the drive have been set.
The blind/shutter is at its upper end position.
1. Traverse the blind to the desired position with the
DOWN
key. Keep pressing the DOWN button.
2. Press the STOP key also. The blind will stop. The status
display lights up brie fl y.
The intermediate position is programmed.
4.6.6 Programming the ventilation/tilting position
in the receiver
Requirement
The transmitter is now programmed.
The end positions of the drive have been set.
The blind/shutter is at its lower end position.
• Traverse the blind in the UP direction with the
UP key
until the ventilation gaps open or the slat tilt position
is reached. Keep pressing the
OPEN button while it is
moving. In addition press the STOP button. The blind will
stop. The status display lights up brie fl y.
The ventilation/tilt position is programmed.
Approaching the intermediate position
Requirement
The transmitter is now programmed.
The blind/shutter is at its upper end position.
1. Press the
DOWN button brie fl y twice. The status display
lights up brie fl y.
2. The blind travels to the stored intermediate position.
Venetian blinds are automatically tilted after reaching
the intermediate position if a tilting position has
been programmed. If an intermediate position is not
programmed, the blind moves down to the bottom end
position (not if Combio Pulse is used).
Approaching the ventilation/tilting position
Requirement
The transmitter is now programmed.
The blind/shutter is at its lower end position.
1. Press the
OPEN button brie fl y twice. The status display
lights up brie fl y.
2. The blind travels to the stored ventilation / tilting position.
If a ventilation/tilting position is not programmed, the blind
moves down to the bottom end position (not if Combio
Pulse is used).
4.6.7 Deleting positions/deleting transmitters
Deleting the intermediate position in the receiver
1. Press both the STOP button and the DOWN button.
2. Press and hold this key combination for approx.
3 seconds. The status display lights up brie fl y.
Deleting the ventilation/tilting position in the receiver
1. Press both the STOP button and the OPEN button.
2. Press and hold this key combination for approx.
3 seconds. The status display lights up brie fl y.
Deleting the transmitter channel in the receiver
• Press both the STOP key and the programming button P
(back of the device).
3. Press and hold this key combination for approx.
6 seconds until the status display lights up brie fl y orange
and then red.
The channel (or the group) in the transmitter is also
deleted.