34 | EN
EN | 35
Important
:
If the blind does not stop, it must be programmed again.
A programming process can be cancelled by pressing
the
STOP
key for six seconds.
4.6.1 Programming additional transmitters
Important
:
If
multiple receivers
are connected to the
same feeder
,
they are all in programming mode for approximately
5 seconds after switching on the power.
If the
P
button on the transmitter is pressed, all the
receivers start programming mode at the same time
(movement up and down). Randomly different intervals
between movements up and down cause the receivers
to become offset against one another. The longer
programming is delayed, the greater the offset will be.
You can stop the short movements up and down by brie
fl
y
pressing the
STOP
button on a transmitter which has
already been programmed. Programming mode in the
receiver is cancelled.
You can now assign the transmitter without having to
disconnect individual receivers. If the blind moves in
the wrong direction, delete the transmitter and restart
the programming process (see Chapter 4.6.7 "Deleting
positions/deleting transmitters").
If you wish to program additional transmitters to a receiver:
1. Press the
OPEN
and
DOWN
keys and the programming
button
P
(back of the device) simultaneously (for 3
seconds) on a transmitter that is already programmed
for the receiver. The status display lights up brie
fl
y. The
receiver is now in programming mode.
2. Press the programming button P on the transmitter to
be programmed, until the status display lights up brie
fl
y.
The receiver is now in programming mode (movements
up and down).
3. Press the
OPEN
key immediately (maximum 1 second)
after an upward movement has started. The status
display lights up brie
fl
y. The blind stops brie
fl
y, starts
moving again, stops and then moves in the DOWN
direction.
4. Press the
DOWN
key immediately (maximum 1 second)
after the start of a downward movement. The status
display lights up brie
fl
y. The blind stops.
The transmitter is now programmed.
If more than 10 bidirectional receivers are being
programmed at the same time, the transmitter channel in
programming mode switches to group mode. Group mode
is indicated by fast
fl
ashing with pauses.
Programming in group mode is terminated after 2 minutes
without pressing a key or the joystick or by pressing the
STOP
key for 6 seconds.
Important:
For venetian blinds, a jogging mode for quickly reaching
receivers which are further away is not possible in a
transmitter channel with more than 10 programmed
receivers.
Summary of Contents for 179086
Page 1: ......
Page 24: ...44 EN...
