Griesser 179086, Operating Instructions Manual

Page: 14 / 24

24 | EN
EN | 25
4.4.5 Selection button
Press the selection key brie fl y to query the current
automatic status and the receiver position of the
programmed receiver and to update on the hand-held
transmitter.
After pressing the key brie fl y, all channels, including
channels that have not been programmed yet, can be
selected with the joystick for 30 seconds; after 30 seconds
only the programmed channels are visible.
Press the selection key for a longer time (longer than
1 second) to switch the operating mode of the channel
(between "Auto" and "Manual").
"Manual" operating mode :
The operating mode indicator lights up red and the
operating mode in the display switches between "manual"
and "automatic".
• The receiver now carries out manual travel commands
only and does not respond to automatic travel
commands.
Important:
All automatic functions are disabled in the receivers, the
receiver does not respond to automatic timer commands
and shading commands from programmed sensors.
Exception:
Alarm movements are a result of reported alarms of
corresponding sensors (e.g. wind and rain sensors) are still
executed.
"Automatic" operating mode :
The operating mode indicator shows green and the
operating mode display switches to "Auto".
• The receiver now executes automatic
and manual travel
commands.
Important :
Switching the operating mode in the master channel
changes the "Auto" or "Manual" operating mode for all
individual channels.
Switching the operating mode within a group changes
the "Auto" or "Manual" operating mode for all individual
channels of the group.
A different "Auto" and "Manual" operating mode in individual
channels is shown in the display with an orange operating
mode indicator and "Automatic icon"
and "Manual icon"
side by side.
4.4.6 OPEN, DOWN and STOP keys
Actuating the keys initiates a travel operation or a stop in
the channel of the programmed receiver.
4.5 Menu mode
The functions of the device are divided into menus.
In the initial display select "Menu" and then the desired
menu or submenu.
Exiting the current menu level : Select "Back", if
necessary select "Back" repeatedly until you are returned
to the initial display or otherwise press and hold "Back".