H74.0.05.6C-06
Operating Manual GMH 3651
page 3 of 18
2 Designated Use
The GMH 3651 is measuring dissolved oxygen in Water.
The measuring is performed by means of a suitable oxygen sensor (included in supply in standard
instrument) connected to the Mini-DIN socket, the sensor measures at the membrane at the tip of the sensor.
Due to the properties of the sensor, it has to be calibrated regularly (e.g. at fresh air = 20.95%) to get precise
values. If the sensor is used up, this will be detected during the calibration, the sensor has to be regenerated
or replaced before continuing with measuring.
The safety requirements (see below) have to be observed.
The device must be used only according to its intended purpose and under suitable conditions.
Use the device carefully and according to its technical data (do not throw it, strike it, …)
Protect the device from dirt.
3 Safety
3.1 Safety signs and symbols
Warnings are labeled in this document with the followings signs:
DANGER
Caution!
This symbol warns of imminent danger, death, serious injuries
and significant damage to property at non-observance.
Attention!
This symbol warns of possible dangers or dangerous
situations which can provoke damage to the device or environment at
non-observance.
Note!
This symbol point out processes which can indirectly influence
operation or provoke unforeseen reactions at non-observance.
3.2 Safety guidelines
This device has been designed and tested in accordance with the safety regulations for electronic devices.
However, its trouble-free operation and reliability cannot be guaranteed unless the standard safety measures
and special safety advises given in this manual will be adhered to when using the device.
1. Trouble-free operation and reliability of the device can only be guaranteed if the device is not subjected
to any other climatic conditions than those stated under "Specification".
If the device is transported from a cold to a warm environment condensation may cause in a failure. In
such case make sure the device temperature has adjusted to the ambient before trying a new start-up.
2.
If there is a risk whatsoever involved in running it, the device has to be switched off
immediately and to be marked accordingly to avoid re-starting.
Operator safety may be a risk if:
- there is visible damage to the device
- the device is not working as specified
- the device has been stored under unsuitable conditions for a longer time.
In case of doubt, please return device to manufacturer for repair or maintenance.
3.
Do not use these products as safety or emergency stop devices or in any other application
where failure of the product could result in personal injury or material damage.
Failure to comply with these instructions could result in death or serious injury and material
damage.
4.
This device must not be used at potentially explosive areas! The usage of this device at
potentially explosive areas increases danger of deflagration, explosion or fire due to
sparking.
DANGER
DANGER
DANGER
