Gregoire Besson SP9 COMPACT, Instruction Of Utilization And Maintenance

Page: 63 / 108

Operation manual SP 9 - Compact
CHAPTER VII – PREPARATION OF PLOUGH BEFORE THE OPERATION – Page
3
7.3. THE ADJUSTMENT OF THE WORKING WIDTH
The Compact plough every working width can be adjusted accordingly to plough bottom distance
between 12’’ to 20’’ or 14’’to 22’’ . In the next table you can chose the suitable working width
between the plough botom distance. The « X » width suits the working angle.
« X »
working
angle
A B C D E
Distance of
the plough
heads 1000
mm
309 mm
(12’’) 358 mm
(14’’) 407 mm
(16’’) 454 mm
(18’’) 500 mm
(20’’)
Distance of
the plough
heads 1140
mm
352 mm
(14’’) 408 mm
(16’’) 468 mm
(18’’) 518 mm
(20’’) 570 mm
(22’’)
The working width is given in mms, as well the
most precise value of the colls.
If it is necessary this angle can be modified, for itt
he plough should be put into the working position,
the plough heads should be 10 cm lifted from the
ground.After that you should adjust the screw-bolts
into the necessaty position.
Mode of operation:
a) Disengage the screw-bolts on the front part of the bearing..
b) Put hte rear screw-bolt into the necessary « X » position.
c) Fasten again the screw-bolts on the front part of the bearing.
d) Fasten the rear screw-bolt.
e) Continue with the next plough bottom.