Gregoire Besson SP9 COMPACT, Instruction Of Utilization And Maintenance

Page: 73 / 108

Operation manual SP 9 - Compact
CHAPTER IX – FIELD SETTINGS – Page
5
9.6. THE SECOND COURSE
Before start the second course do not forget to close the adjuster of first furrow width. If you don’t
know the reference position of first furrow, then take for base the middle stokr of cylinder.
Before the final adjustment:
Make sure, that after some hours operation the breasts polished suitably. For soil must to pass
trough without any sticking.
Sometimes on peatly or claily soils it possible, that the soil stick to metal in further too. Besides
such conditions – as often as possible – clear the breasts, entirely the soil pass trough without
sticking. See in chapter 7.5 in this Manual (Preparing the new breasts to operation). Such extreme
conditions may be required plastic breasts. Consult your GRÉGOIRE-BESSON dealer who can
help you the choice of the best technical solution.
9.6.1. PUTTING THE PLOUGH INTO THE LEVEL
In the second course the wheels of the tractor are going in the furrow.
For good ploughing the side part of the plough (inclination from left to right) as well as in longitudinal
should be on the same level (from front to back)
9.6.1.1. The adjustment of the third point position (pusher)
The adjustment of the third point position is
performed when the tractor is in the furrow (second
course) with the plough being put on the ground.
During the work the third point should be higher on
the side of the plough (X < Y) usually one hole
vertically.
From the side of the tractor using the hinge the
height can be changed. The height adjustment from
the side of the plough is performed by three point
mounting device on the pull-rod with the help of
different holes.