Pellet burner GP 45 IV 35
6.3.
REGULATING THE BURNER’S HEATING OUTPUT.
The burner heating output regulation can be performed by adjusting the level defining its
output. Information about the burner heating output for every level is presented in Table 6.1.
If the used fuel type has been changed (change of the wood pellets category) a
new adjustment of the burner’s heating output level might be required.
6.3.1. DECREASING THE BURNER’S HEATING OUTPUT.
It can be achieved by reducing the burner’s heating output level, which decreases the
assigned heating output and respectively the fuel consumption.
6.3.2. INCREASING THE BURNER’S HEATING OUTPUT.
The burner’s heating output increase can be achieved by increasing its heating output level,
which increases the assigned heating output and respectively the fuel consumption.
If the heating output, respectively the fuel consumption, have been changed, the
control module algorithm automatically changes the fresh air flow rate, supplied
by the fan, which provides optimal operation mode within wide heating output
range.
6.4.
STOPPING THE BURNER OPERATION.
Stopping the burner operation can be achieved by its control module, which submits
operation signal. Restore of the burner operation can be achieved by changing the control
module adjustment, which commands the burner operation. In case operation is not needed
for longer period of time, then the burner combustion chamber has to be cleaned from the
ash deposits and also to cut off the appliance power supply to which it is connected.
6.4.1 STOPPING THE BURNER OPERATION BY THE SWTICH “START”.
By the switch “START” (which has to be installed by the servicing technician during the
burner installation, according to the attached wiring diagrams) the burner can be switched on
and respectively switched off. If it is switched off the display shows message “FINAL
COMBUSTION”.
The burner stopping must be performed only by the switch “START”, and not by
cutting off the appliance main power supply. By stopping the burner by the switch
“START” it performs controlled shut down process, during which the appliance
cools down, completes the rest fuel burning and saves the appliance reliability.
6.4.2. STOPPING THE BURNER OPERATION BY THE CONTROL MODULE MENU.
To stop the burner operation it is necessary to complete the following actions:
Press and hold the button “ESC” for more than 5 seconds;
Choose answer “YES” when asked to “Make final combustion?“ on the display;
