Pellet burner GP 45 IV 22
Figure 5.6. View of a fuel transport auger mounted to a fuel hopper with additionally installed
storey.
The flexible pipe must be linked to the transport auger and the main module, so it
is fully stretched (without bents and hangings, where the fuel or fuel dust could be
gathered) and after that it has to be fastened with the attached brackets.
5.5.
INFORMATION ABOUT INSTALLATION POSSIBILITIES OF PELLET BURNER
FROM SERIES “GP” AND JOINT OPERATION WITH HOT WATER BOILERS.
The automated pellet burner from series „GP” is individual module (requiring electrical supply
and signal – assignment for operation), that can be mounted to heat energy consuming
appliance. The practice shows that in most cases the heat energy consumer is a hot water
boiler for local heating installations. The manufacture company had accomplished continues
tests for compatibility, reliability and efficiency of the burner and series of popular hot water
boilers. Depending on the hot water boiler construction it is possible to use additional
transitional components and modules, which improve the system operation: pellet burner –
hot water boiler and ensure, and increase its efficiency and reliability.