46
M_LS900 Fibre - LS900 Edge_EN_C
Adaptable accessories
4. Compressor kit (air assist)
Used to deliver compressed air for the Air assist function without having to connect an external compressor to
the air inlet (compressed air supply for air assist).
Compressed air: 1 Bar (14.504 PSI) - 12.4 l/min - Tap open
This accessory is pre-assembled on a plate to install on the machine.
Installation - Use: refer to the manual.
5.
Honeycomb cutting table
Used to support the material to be cut at a distance from the surface of the engraving table to minimize the
area of contact with the surface. The cutting table redirects the exhaust air over and under the material to clear
the engraving area of fumes.
To limit the reflection of laser beam, the honeycomb material is reflective only in the area in contact with the
material.
Installation:
1. Set the cutting table down on the machine's engraving table.
2. Place the cutting table so it is resting against the strips of the engraving table.
1
2
