S1001.G1 and S1001.G1.77-USA-V1.0
15 / 33
LED Panel and Buttons
1
MODE button
Press and hold while switching on the transmitter:
Starts the firmware update
Activates the Fail-safe setting
Transmitter switched on:
Binding transmitter and receiver
Short push takes a snapshot through the camera (optional)
Push for 2 seconds: select video channel (optional)
2
CUT-OFF
Red LED blinks: Motor/throttle cut-off is ON
Red LED off: Motor/throttle cut-off is OFF
3
RATE
Red LED on: Rate mode active (Advanced Mode)
Red LED off: Attitude mode active (Beginner Mode)
4
CH6
Red LED on: Flip mode active (for 5 seconds only)
5
CH7
Red LED lights: upper right switch on LED position
6
CH8
Red LED off/on: indicates the video resolution depending on the
used video system used (optional)
7
ENTER button
Short push starts and stops video recording (optional)
Push for 2 seconds changes the video resolution (optional)
8
BIND LED
Yellow LED on: the transmitter is bound to the flight
controller/receiver
9
-100 %
Green LED blinks: camera snapshot (optional)
10
+100 %
Green LED blinks: Video recording on (optional)
1 + 7
Pushed simultaneously - starts and stops the range test
