S1001.G1 and S1001.G1.77-USA-V1.0
13 / 33
Transmitter First-Time Use
Power Supply
The mz-10c Multirotor transmitter comes with 4 non-rechargeable AA
batteries.
Installing the Batteries
WARNING
Never recharge alkaline batteries. Batteries may explode.
Note
Make sure to insert the batteries into the correct position for proper
contact.
WARNING
Faulty battery installation can interrupt the power supply to the
transmitter. This can cause the transmitter to malfunction and risk damage
to your receiver, yourself or others.
Replacing the batteries step by step:
1.
Locate the battery compartment in the back of the transmitter.
Slide the case cover down until it is disengaged.
2.
Remove the cover.
3.
The battery box is fixed in the compartment with Velcro tape. Lift
the lower side of the battery carefully.
4.
Gently pull the connecting plug to loosen the battery box wires.
5.
Remove the used batteries from the battery box.
6.
Insert new AA batteries.
7.
Reconnect the plug to the port inside the battery compartment.
(
Plus pole
= red cable,
minus pole
= brown or black cable).
8.
Place the battery box in the battery compartment and press to
reattach to the Velcro tape.
9.
Close the battery case with the cover.
If you have inadvertently connected the plug in wrong position, the
transmitter will not switch on.
