GRAUPNER MZ-10 HOTT, Manual

Page: 37 / 48

37 / 48
S1042_sh_V1
• Note that the chosen fail safe settings are saved in the receiver.
The fail safe settings should be restored after changing a receiver
and should be deleted in the previous receiver by resetting.
• In the course of storing fail-safe settings, any change to "France"
will be lost and must be renewed.
Fail-safe variant selection
Note
The fail-safe setting is only possible in connection with the activa-
tion of the "NORMAL" use mode.
Set the transmitter to the programming mode Fail-Safe
Switch off the transmitter and move the TRAINING switch on the
transmitter right side in the "NORMAL" position. Push and hold the
MODE button on the left of the LED panel while switching on the
transmitter. Release the button after having switched the transmit-
ter on and power the receiver previously bound to the transmitter.
The transmitter BIND LED should then light on yellow.
The transmitter is now in Fail-safe mode. Switch between the four
options by briefly pressing the MODE button on the left of the LED
field in the rotary process:
push the
MODE
button
active mode Status LED and buzzer
0x Fail Safe repeated 1x blink and 1x beep
1x Hold repeated 2x blinks and 2x beeps
2x Off repeated 3x blinks and 3x beeps
3x Standard repeated 4x blinks and 4x beeps
Mode "Fail-safe"
In case of interference the servos take a preset position for a "hold"pe-
riod of 0,75 seconds.