GRAUPNER MZ-10 HOTT, Manual

Page: 41 / 48

41 / 48
S1042_sh_V1
Later in the preparations it is possible to adapt the servo direction,
especially of CH1, to the habits of the student.
Preparing teacher and pupil transmitter
Teacher transmitter
Bring the mz-10 HoTT teacher transmitter in "TEACHER" use mode
or program the other teacher transmitter accordingly to its manual.
Pupil transmitter
Bring the mz-10 HoTT pupil transmitter in "PUPIL" use mode or pro-
gram the other pupil transmitter accordingly to its manual.
Note
The mz-10 HoTT transmitter remains after a conversion of the con-
trol mode, completely independently from the occurred setting of
the TRAINER switch and even after switching on again the transmit-
ter, in the last selected use mode until this will be changed.
Binding both transmitters
During the binding process, the distance between the two transmit-
ters should not be too small (up to 2m). However, always keep a suf-
ficient distance from the HoTT receiver already bound to the pupil
transmitter. In case of too small distance because of the back chan-
nel redundancies it is possible that some errors are signaled.
Programming
Pupil transmitter
Push and hold the MODE button on the switched on
mz-10 HoTT
pupil transmitter until the first beep is emitted or activate the bind-
ing process accordingly to the other HoTT pupil transmitter manual.
Teacher transmitter
Push and hold the MODE button on a mz-10 HoTT teacher transmit-
ter until the first beep is emitted or activate the binding process
accordingly to the other HoTT teacher transmitter manual.
If the binding process is successful, both transmitters will indicate
each in its way the correct binding. By transmitter type mz-10 HoTT
e.g. through the light up of the yellow BIND LED. Otherwise change
the distance and repeat the process.