36 / 48
S1042_sh_V1
A short beep is emitted after release.
7. As after every transmitter switching on, the seven LEDs light and/
or blink for approx. 5 seconds to indicate the actual selected set-
tings.
Fail Safe
The "Fail Safe" function determines the response of the receiver
both by directly switching on the receiver system and when there is
an interruption in transmission from the transmitter to receiver.
Note
By default, the center position is specified for all receiver outputs
until the fail-safe positions are saved for the first time.
The servos connected to the receiver outputs 1 to 5 can then ...
• ... after the receiver is powered on and until there is no valid sig-
nal from the transmitter, take the positions saved in the receiver.
Completely independently from receiver settings "hold" or "pos".
• ... in case of interference ...
ശ
... ("HOLD").
In case of transmission interruptions, all servos programmed
to "hold" remain at their position which was last identified to
be correct until a new, correct control signal is received by the
receiver.
ശ
... after the preselected "failsafe delay" move to a selectable
position ("pos").
Notes
• Use this safety option to program a Fail Safe for at least the
throttle position in gas models while idling, or to program the
motor function to stop with electric models, or to hold with heli-
copter models.
• Pay attention in the following described setting, that an already
connected motor does not start accidentally during the test of
the selected option.
Summary of Contents for MZ-10 HOTT
Page 2: ...2 48 S1042_sh_V1...
Page 48: ......
