GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors 11/2010
11
Trim the outside edges of the plastic holder so that it fits in the recess in the wing.
Route the diode leads to the root rib using a length of thread, and run them out of the
access hole in the centre. The plastic holder can now be glued in the wing using UHU
Kraftkleber adhesive. Fix the glazing to the wing using clear adhesive tape.
Use your fingertips to locate the holes for the wing retainer screws in the wing root
area, and remove the covering film over them using the tip of a hot soldering iron.
Fuselage, tailplane, fin and noseleg
There are two options here: either the fin can be glued permanently to the fuselage,
or the tail assembly can be left detachable for ease of transport. In both cases the
tailplane panels are attached to the fin using an aluminium joiner tube and eight
socket-head screws
