GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Modifications reserved. No liability for printing errors Id. No. 0061845 04/2010
11
Lay the tailplane on the fuselage at right-angles to the centreline, and drill the screw-
holes using a 3.2 mm Ø bit. Drive the tapping screw (72) into the holes in the fuse-
lage (71) to cut an M4 thread in them. Drill out the screw-holes in the tailplane to 4
mm Ø, and countersink them for the plastic M4 countersunk screws (73).
Wing mounting
Apply the foam tape (74) to both sides of the wing saddle on the fuselage (71).
Join the wing panels using the flat steel joiner (76), and mark the position of the wing
locating dowels (73) on the fuselage. Drill holes for the dowels, and adjust them if
necessary using a needle file until the wing rests flat on the wing saddle (check also
that the wing is exactly central).
