GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Changes reserved! No liability for printing errors ID. no. 0063067 07/2012
14
Assembly of the ASH 31 MI
Insert the wing halves on the hull using the mating so that the servo connection
cables can be connected; then push both wing halves all the way onto the hull so that
the root ribs are against the hull; insert the four anti-twist devices in the holes of the
profile recesses of the hull. The two wing halves are secured by screwing in the
locking screws with washers from the inside of the hull.
Fit the outer wing on the inner wing using the GRP round bar and push together until
the plastic locking devices engage.
Fit the winglets and secure them using strips of adhesive tape.
Fasten the tailplane on the hull using the two M5 Allen screws. Only tighten the
screws until the tailplane fits against the profile recess without play.
Fasten the cockpit canopy on the hull using the GRP tongue in the front and using
the steel pin in the back.
Balancing the ASH 31 MI
Support the model to the left and right of the hull approx. 95 mm behind the leading
edge of the wings. If the center of gravity is correctly positioned, the model stop
rocking back and forth at a horizontal attitude or the hull nose should point slightly
downward. If necessary, the center of gravity can be moved by shifting the position of
the battery or attaching trim weight. Before the initial flight, all rudders must be moved
precisely to the center position (zero position) with the transmitter trim adjustment in
the middle.
