GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Changes reserved! No liability for printing errors ID. no. 0063067 07/2012
8
Adhere the boards for the receiver and drive battery fastening in the hull as shown in
the two photos.
In the following photo you can see the installation of the voltage regulator PS 5.9 volt.
The cockpit canopy
The cockpit canopy frame must be adapted to the hull. In other words, it must sit
back in the outer hull contour an equal distance all the way around corresponding to
the size of the cockpit canopy. The front fastening of the frame is achieved with a
GRP tongue, which is adhered to the frame so that it protrudes approx. 15 mm.
For the rear fastening of the frame, a Ø 2 mm hole is drilled through the frame and
hull approx. 4 mm below the upper edge of the hull while the frame is in position.
