GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Changes reserved! No liability for printing errors ID. no. 0063067 07/2012
7
Drill a Ø 2 mm hole on the left and right side of the hull for the bearing shaft of the tail
wheel corresponding to the specifications in the photo. Mount the tail wheel together
with the bearing shaft in the hull. Adhere the bearing shaft on the right and left sides
of the inside of the hull.
Check whether the rudder can move equally far to the left and right. Remove the
rudder, apply adhesive to the GRP bearings and re-insert the rudder and bearings in
the same position. Secure the rudder against slipping with adhesive strips until the
adhesive hardens. After the adhesive hardens, mark the position of the control arm.
Drill a Ø 4 mm hole in the rudder. Attach the steering linkage in the servo lever and
with the Z-bending in the control arm. Check the correct length of the linkage with the
servo mounted in the rudder center position and the control arm connected. Now
adhere the control arm to the rudder with adhesive.
