GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Changes reserved! No liability for printing errors ID. no. 0063067 07/2012
10
The cable on the servo can be left for the connection of the servo to the receiver, or it
can be soldered to a G 6 plug (as shown in the photo), which is adhered in the
recess. In parallel, the counterpiece must be adhered to the elevator support in the
hull. Extreme care must be taken in the process in order to ensure that the plug
connection does not come loose again. For the fastening of the tail on the hull, the
two fastening holes must be melted open using a hot soldering iron.
The wings
Mount the control arms as shown in the photos below. Adjust the length of the
linkage. The steering linkage for the rudders is comprised of an M2 clevis and M2
threaded rod, which has a double bend for attachment to the servo arm (Bending
pliers Order no. 5732). Cut or file slots in the rudders up to the leading edge of the
rudders in order to accommodate the control arms. In doing so, make sure that the
control arms can be pushed in / adhered to the upper covering.
Important: The adhesive bonds of the
control arms with the rudders should be made with 24-hour epoxy resin.
For the installation of the servo, scrape out a recess in the hard foam core up to the
upper covering. Now apply adhesive and adhere the servo mounting frame.
The servos for the landing flaps are also
