GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Changes reserved! No liability for printing errors ID. no. 0063067 07/2012
12
Before adhering the torsion pins, they must be roughened at the points to be
adhered. When adhering, approx. 15 mm should protrude from the root ribs.
As is shown in the photo, the servo connection cables can be run together using a G
6 plug connector. Attach the wiring harness in the hull from the receiver to the plug
connection. In the process, the plus and minus leads can be run together. Then they
can be soldered to the respective outside contacts. Then there is still a contact
available for the impulse lines.
Important: The correct polarity must be absolutely assured.
The outer wing
First adhere the anti-twist devices in the root ribs of the insertable wings as described
for the inner wings; these should protrude approx. 10 mm from the root ribs.
Tip: Place a layer of household plastic foil between the wing sections and lightly
grease the pin (not on the side to be adhered). In doing so, you prevent the wing
sections from sticking together and/or prevent the pin from adhering to the sleeve
with any escaping resin.
