7-012 Setting the Angles Between the Drawer Front and the Drawer Bottom
Illustration 7-012-01
- Produce a complete drawer, according to Section 7-3.
- Check the drawer for various defects, according to Section 8.
- Correct the determined deficiency, according to Section 8.
- Produce another complete drawer, according to Section 7-3.
- Check the new drawer for various defects according to Section 8. If no defects occur, then the angle between
the drawer front and the drawer bottom can be set.
The angles are set by setting both the left and right front supports.
Necessary tools:
Open-end fork wrenches, 13 mm and 17 mm
Allen key wrench, 4 mm
- Loosen the lock nut „1“.
- Screw out the hexagon head screw „2“ about 2 mm.
- Adjust the set screw „3“ in the steel component „4“ with an Allen key wrench.
If the angle is less than 90 degrees, then the set screw must be screwed in.
If the angle is more than 90 degrees, then the set screw must be screwed out.
- Tighten the hexagon head screw „2“ manually and then tighten it about 1/4 turn with an open-end fork
wrench.
- Tighten the lock nut „1“.
- Adjust the second side.
- Make another complete drawer, according to Section 7-3.
- Check the new drawer for angle defects.
- If necessary, repeat the angle adjustment until the angles are correct.
7. OPERATING THE ZPM
The star in your cabinet
33
Summary of Contents for ZPM
