GRASS ZPM, Operating Instructions Manual

Page: 19 / 48

5. SHIPPING AND INSTALLATION OF MACHINES
The star in your cabinet
19
5-002 Space and Environment Requirements
The necessary space requirements depend on the quantity of the available individual assembly components
and the quantity of the stored finished drawers.
The minimum depth dimensions required are about 200 cm.
The minimum width dimensions required are about 200 cm.
The machine must be kept in a dry room away from humidity and moisture.
The surrounding temperature of the operating machine should be b10 degrees Celsius and +40
degrees Celsius.
The relative humidity should in the range of 10% to 80% and should be non condensing.
The machine may malfunction or become damaged with large deviations in extreme environmental conditions.
5-003 Assembly at the Final Installation Site
The Zarge press is shipped to its final installation site with a low lift platform truck or a fork lift truck. Once there,
the dual sided shipping security wood beams are dismantled. The machine is placed on the floor. Please make
sure the machine is on a level surface.
If need be, the machine frame can be leveled out under one of the 4 corners. We strongly recommend bolting
or screwing the machine to the floor.
Now both security bands (used for shipping safety), which hold the unit carriers to the machine frame, can be
removed.
Once the machine is installed at the final location, the pilot run operation can be initiated, according to
Section 6.
Note:
In order toa void the dangerous position behind the Zargen press, please comply with the following measures:
Recommended:
a) Place the Zargen press as closely to a wall as possible, or
b) Attach a closure on the side and behind the Zargen press. This is available as a special accessory from
Grass Inc.
Safely securing the ZPM is the responsibility of the Zargen press owner.
5-004 Requirements of Operating Personnel
This machine may only be operated by trained personnel that are familiar with operation of the machine. This
training may come from on-the-job training by a specialist or by thoroughly studying the operating instructions.
The operators must be mentally and physically capable of operating this machine. It is the machine
owner’s responsibility to ensure that the machine operators are capable and knowledgeable about using this
machine.
The machine operators must be responsible and not allow other persons near the machine when it is being
operated.
The machine owner is responsible for making sure compliance of these requirements are met.