8-005 Gap Between the Zargen Slide and Bottom Inside the Drawer
Possible Reasons > Solving the Problem
- The bottom groove space is too small. > Correct the space.
Specified dimension = 12-0.5 mm, Ideal dimension = 11.7 to 11.8 mm
- The bevels on the bottom are missing or are too small. > Attach bevels.
8-006 Correcting the Angle Between the Drawer Bottom and the Drawer Front
Possible Reasons > Solving the Problem
Set the angle according to Section 7-012.
8-007 Back Wall Dowel Is Not Inserted Properly / Gap Between the Back Wall and Zargen Slide
Possible Reasons > Solving the Problem
- The screws in the back wall - compression die fence do not press hard enough on the dowels. > Screw the
screws further out.
- The bore holes in the back wall are not deep enough. > Drill the bore holes deeper.
- The bore holes in the back wall are not in the proper position. > Correct the bore holes spacing.
- The set dimension „A“ Section 7-010 is too small. > Correct according to Section 7-010.
8-008 Drawer Cannot Be Removed Easily From the Zarge Press ZPM
Possible Reasons > Solving the Problem
- The set dimensions „A“ Section 7-010 is too small. > Correct according to Section 7-010.
8. TROUBLE SHOOTING AND PROBLEM SOLVING
The star in your cabinet
35
Summary of Contents for ZPM
