GRASS VALLEY PROFILE XP PVS Series, System Manual

Page: 336 / 352

Chapter C
336
Profile XP System Guide 23 July 2004
Installing the Profile XP on the rack mount rails
To install the Profile XP on the rack mount rails:
1. Pull the slide-out track section to the fully extended position.
WARNING: To prevent injury, two people are required to lift the Profile XP. It is
too heavy for one person to install in the rack.
WARNING: To prevent serious injury, insure that the rack is anchored to the floor
so that it cannot tip over when the Profile XP is extended out of the rack.
2. Insert the ends of the chassis sections into the slide-out sections.
3. Push the chassis toward the rack until the chassis sections lock into the intermediate
sections.
4. Press the stop latches in the intermediate sections and push the chassis toward the
rack until the latches snap into their holes.
5. Again, press the stop latches and push the cabinet fully into the rack.
6. Insert and tighten the front panel retaining screws.
Making Rack Slide Adjustments
After installation, binding may occur if the slide tracks are not properly adjusted. To
adjust the tracks:
1. Slide the chassis out approximately 10 inches.
2. Slightly loosen the mounting screws holding the tracks to the front of the rails and
allow the tracks to seek an unbound position.
3. Tighten the mounting screws and check the tracks for smooth operation by sliding
the chassis in and out of the rack several times.
4. Tighten the front panel retaining screws once the cabinet is in place within the rack
to complete the installation.
!
!
Stop Latch