19
Kahuna
Installation Manual
Mounting a MAVRow Frame into a Desk
The MAVRow frame has to be empty of any MAV modules or Blanking modules before
attempting to insert the frame into the desk.
With the desk cut to the correct size, the MAVRows are secured into a desk using appropriate
counter sink flat head wood screws. At each end of the MAVRow frame there are fixing point
holes for the screws (as shown on the diagram below).
Note:
The MAVRow frame should preferably be mounted in a desk which is
open underneath.
If the desk is not open underneath, enough room has to be left underneath
for ventilation and for routing the PSU and Comms cables to the underside
of the MAVRow frame.
Important: The cutout has to be a minimum of 110mm (4.3 inches) into the
desk to allow clearance for cables and airflow underneath the MAVRow
frame.
Note:
It is essential to ensure the air temperature does not exceed 40
°
C
Note:
Make sure that every MAVRow is secured to the desk using the
fixing points at both ends.
Fixing point
Screw Holes
