17
Kahuna
Installation Manual
How to calculate a Desk Cut-out Width and Depth
Cut-out Width
- The calculation is:-
Total Width MAV Modules and Blanking Modules in a row + 29 mm (1.14 in)
.
Cut-out Depth
- The calculation is:-
Number of Rows x 140 mm - 5 mm
(
Number of Rows x 5.15 in - 0.19)
.
Example:
In the diagram below, the black line is the outline of if control surface from the previous page.
The calculation below describes how to calculate the cut-out (red dotted line) for the control
surface.
Cut-out Width
- Add up all the
Widths
of the MAV modules (bottom row):-
160 mm + 160 mm + 200 mm + 160 mm + 100 mm = 780 mm
Then add 29 mm to that total:- 780 mm + 29 = 809 mm (cut-out Width).
Calculation in Inches
:-
6.29 in + 6.29 in + 7.87 in + 6.29 in + 3.93 in = 30.67 in
Then add 0.98 into that total:- 30.67 in + 1.14 = 31.81 in (cut-out Width).
Cut-out Depth
- 140 mm x 3 = 420 mm, then take away 5mm = 415 mm (cut-out Depth).
Calculation in Inches
:-
5.15 in x 3 = 15.45 in, then take away 0.19 in = 15.26 in (cut-out Depth).
Note:
The cutout has to be a minimum of 110mm (4.3 inches) into the desk
to allow clearance for cables and airflow underneath the MAVRow frame.
Note:
Widths of MAV Modules and Blanking Modules can be found in Table
1 and Table 3 of this manual.
809 mm
4
15 mm
CUT-OUT Area Red Dotted Line
Example of a Control Surface Cut-out
