GRASS VALLEY K2 BASECAMP EXPRESS, Instruction Manual

Page: 29 / 394

July 3, 2007 K2 Storage System Instruction Manual 29
Setting up the Level 2 GigE switch
Refer to “Level 2 system description” on page 26 for a diagram of the complete
system.
Refer to cabling procedures later in this chapter for the GigE connections at each of
the devices of the K2 Storage System.
Also refer to “K2 Ethernet switch description” on page 285 and “Design
considerations for Ethernet switches” on page 388 .
Configuring the GigE switch via serial connection
The following procedure is for the HP ProCurve switch and applies to both the 3400cl
series and 2900 series switches.
Use a direct console connection to the switch, start a console session, and access the
Switch Setup screen to set the IP address.
1. Configure the PC terminal emulator on the control point PC or another PC as a
DEC VT-100 (ANSI) terminal or use a VT-100 terminal, and configure either one
to operate with these settings:
• Baud rate 115200
• 8 data bits, 1 stop bit, no parity, and flow control set to Xon/Xoff
• Also disable (uncheck) the “Use Function, Arrow, and Ctrl Keys for Windows”
option
2. Connect the PC to the switch’s Console Port using the console cable included with
the switch. (If your PC or terminal has a 25-pin serial connector, first attach a 9-pin
to 25-pin straight-through adapter at one end of the console cable.)
3. Turn on the PC’s power and start the PC terminal program.
4. Press
Enter
two or three times and you will see the copyright page and the message
“Press any key to continue”. Press a key, and you will then see the switch console
command (CLI) prompt.
NOTE: If you press Enter too many times and get past the log in, enter the
command EN to get into the command line.
5. Type the following, then press
Enter
:
menu
If prompted to save the current configuration, answer no (press the n key) to
proceed. The main menu opens.
6. On the main menu, choose
Switch Configuration,
then press
Enter
.
7. Select
IP Configuration
, then press
Enter
.
8. Press the right-arrow key to choose
Edit
, then press
Enter
. Tab to fields and enter
information as follows:
a. Change
Gateway
to be the default router.
b. Tab to the
IP Config (DHCP/Bootp)
field and use the Space bar to select the