GRASS VALLEY Creative Grading, User Manual

Page: 49 / 66

Creative Grading Camera Control System User’s Guide (v1.4) 49
Chapter 5 - CGP Operation
5.3.1 Network
To operate in the IP network thee CGP must have a unique identification. By default, the IP
address is assigned automatically: IP Mode = Auto. Set the IP Mode to manual to set or
change the IP Address.
5.3.2 Stick
In this section the range over which the iris opening is controlled by the stick can be set, as
well as its center position. The direction of control can also be set in this section.
5.3.3 Install
The install section contains items to set up the behaviour of the Tally inputs, the CGP’s internal
signal buzzer. It also contains the factory reset function.
Section Setting Values Function
IP Address 169.nn.nn.nn IP address (manual, editable when IP Mode is set to
Auto)
IP Mode Auto , Manual IP address assignment mode
Subnet Mask 255.255.n.n Subnet mask
Default Gateway 255.255.n.n Default Gateway IP address
Network
Section Setting Values Function
Iris Mode Normal , Reverse Selects Iris stick mode
Iris Range 0..99 (50) Sets Iris stick range
Iris Center 0..99 (50) Sets Iris stick center position
Stick
Section Setting Values Function
Tally R Inp Disable, Low/
High, High/Low,
Open/High, High/
Open Selects switching mode of Red Tally/On Air GPIO input
on the preview connector.
Tally Y Inp Disable, Low/
High, High/Low,
Open/High, High/
Open Selects switching mode of Yellow Tally/On Air GPIO
input on the preview connector.
Tally G Inp Disable, Low/
High, High/Low,
Open/High, High/
Open Selects switching mode of Green Tally/On Air GPIO
input on the preview connector.
Buzzer On, Off When switched on, a buzzer signal sounds when a
CALL signal is received from the camera.
Buzzer Lvl 1..16 (8) Sets buzzer audio volume level (when buzzer is
switched on).
Fact Reset Exec Carry out a CGP panel factory reset. All settings are
cleared except the Camera Selection and Network IP
settings. A confirmation popup window is shown to
Confirm or Cancel.
Install