22
6. Interface Setting [I/F]
Click [I/F] on the main screen ( page 9) to open the [Interface] screen.
The settings related to Interface can be done in the [Interface] screen.
CAUTION
When the controller is started from the driver software, select the GP-GL command.
1
Command
Specify the plotting command. Select one of GP-GL command,
HPGL command or AUTO. Select [Auto] to automatically determine
the command.
( Chapter 11: "Settings of Controls from Computer" in the CE6000
User's Manual)
2
GP-GL
Step Size
Specifies the movement distance per step.
Select from 0.100mm, 0.050mm, 0.025mm, and
0.010mm (254 point/inch, 508 point/inch, 1016
point/inch, 2540 point/inch).
Command ":",";"
Enables/Disables Command ":",";".
Command "W"
Specifies whether to raise the tool or keep the
current tool state before moving the tool to the
start point when "W", instruction to draw an
arc, is issued. When [Tool Down] is selected,
the tool moves, keeping the same state (raised
or lowered) as one right before the instruction
is issued. When [Tool Up] is selected, the tool
is raised and then moved. This setting is valid
only when the tool is a cutter blade.
3
HP-GL
Origin Point
Sets the lower left or center of the plotting area
as the origin point.
Model Emulated
Sets the response to the "OI" command. Select
[7550] to set 7550 as the value of the response
to "OI" command. Select [7586] to set 7586 as
the value of the response to "OI" command.
Circle Resolution
Specifies whether to automatically set the
resolution or use the fixed value of 5 degrees
when the instruction to draw an arc is issued.
4
OK
Saves the settings and closes the [Interface] screen.
5
Cancel
Cancels the settings and closes the [Interface] screen.
1
2
5
4
3