21
5. Setting Area Parameters [AREA]
Expand
Broaden or narrow the width of the plotting area.
When the initial value ([Default]) is used, the width expands to the internal edge of the push rollers (See
the figure below).
Select [Set Expand Limit] and enter a negative value to obtain narrower width or enter a positive value
to obtain broader width than when the initial value is used.
The possible values are from -10.0 to +10.0 mm (-0.394 to +0.394 inch).
Push roller
Edge position
Area
Set the plotting area that you want. The square specified by the points that are set by using [Set Upper
Right] and [Set Lower Left] is the plotting area.
This setting is used when, for example, you want to plot on a free area on the plotted media.
To set a plotting area, perform the following procedure:
1. Click [Position (Use Keyboard)].
2. Press one of the [ ] keys on the keyboard to move the tool to the position that you want to set
as the lower left point and click [Set Lower Left].
3. Press one of the [ ] keys on the keyboard to move the tool to the position that you want to set
as the upper right point and click [Set Upper Right].
To use the setting area for use in media setting, select [Default].
Upper right set
position
Image already cut
It will only cut within
this area
Lower left set
position