Graphite 58G945, Instruction Manual

Page: 29 / 125

29
When the filter has been dismantled use the wire hook to hold up the end of the suction line.
Be careful during fuel filter installation to prevent contamination from getting into the suction line.
OIL FILTER
● Unscrew oil filler plug ( 18 ).
Use wire hook to remove the oil filter ( ● h ) through the oil filler hole ( fig. Y ).
Wash the oil filter in petrol or replace with a new one. ●
Remove dirt from the tank. ●
Install the oil filter in the tank. ●
Tighten oil filler plug ( ● 18 ).
When putting the oil filter into the tank make sure it reaches front right corner.
IGNITION PLUG
To maintain reliable operation of the device, check condition of the ignition plug on a regular basis.
Remove air filter lid ( ● 4 ).
Remove air filter ( ● d ).
Remove wire ( ● i ) from the ignition plug.
Put on plug key (included) and unscrew the ignition plug ( ● fig. Z ).
Clean and adjust spacing between contacts (0.65 mm) (replace ignition plug when necessary). ●
OTHER INSTRUCTIONS
Ensure there are no fuel leaks, loosened joints or damages of main parts, especially main handle joints and guide bar
fixing. When you find any damage, make sure it is repaired before next use of the chain saw.
All faults should be repaired by service workshop authorized by the manufacturer.
TECHNICAL PARAMETERS
RATED PARAMETERS
Petrol Chain Saw
Rated parameter Value
Engine displacement 45 cc
Guide bar working length 405 mm
Engine power 1.45 kW
Engine speed with cutting system (maximum) 7500 rpm
Idle rotational speed 2800 rpm
Average fuel consumption 0.9 l/h
Fuel – petrol : oil for 2-stroke engines 25 : 1
Fuel tank capacity 550 ml
Chain oil SAE 10W/ 30
Chain oil tank capacity 260 ml
Carburettor Walbro WT
Ignition system Magneto
Ignition plug L8RTF (Champion RCJ7Y) (NGK BPRM8A)
Oil feed system Automated pump with controller
Chain wheel (teeth x pitch) 7T x 0.325” (8.25mm)
Type of guide bar With chain toothed wheel
Size of guide bar OREGON 445 mm standard
Type of chain OREGON 21BP