22
6.2 Dump Mode
Dump Mode is used to check if there has been an error in printer-to-PC
communication. If the printed labels do not match the label settings,
there may be a printer-to-PC communication problem.
1. Turn the printer’s power off. Press and hold the FEED button, and turn
on the printer.
2. Release the FEED button after hearing 1 beep. The printer will
produce a test strip that reads “Dump Mode Begin.”
3. Start a new print job and see if what is printed matches the command
sent.
To cancel Dump Mode, press the FEED button. This will return the
printer back to standby mode. Dump Mode can also be stopped by
turning off the power
6.3 Auto Sensing
The following instructions are necessary when printing labels with gaps, such as
die-cut labels.
The DuraLabel 7000 can automatically detect label length using the label
black mark positions. This is how to have the printer detect label length:
1. Check the Media Sensor to ensure it is positioned over the vinyl.
There is a mark on the media sensor that indicates the exact
position of the sensor. That mark needs to be located such that
it is directly over any part of the vinyl tape.
2. Turn off the printer. Then press and hold the
Pause
button.
3. Turn the printer on
while still holding the Pause button
. After
printer beeps three times and the LCD screen displays “Auto
Sensing Mode,” release the Pause button.
4. The printer will automatically detect the size and length of the
label, and the LCD screen will show the recorded measurement.
(The printer will go back to standby mode after displaying the
measurement.)
Summary of Contents for DuraLabel 7000
Page 31: ...31 Notes...
Page 32: ...32 2008 2009 Graphic Products Inc All Rights V1 0 6 9 09...
