23
NOTE: You can adjust where the printer cuts to make sure the cut is directly
centered in the gap by adjusting the Stop Position in the Stock tab of the
Printer Properties
.
6.4 Sensor Adjustments for Specialty Stock
When using preprinted Continuous Stripe Vinyl adjust the Gap Sensor so
that it is positioned over a white area of the stock (see illustration below).
If it is positioned over any portion of the preprinted area the printer will
error out. Choose landscape orientation in your print settings (see
orientation guide below).
6.5 Orientation
Create the label with the width and height of the label. If the height of the
label is the width of the tape installed in the printer, set the orientation to
Landscape. If the width of the label is the width of the tape installed in
the printer, then set the orientation to Portrait.
Summary of Contents for DuraLabel 7000
Page 31: ...31 Notes...
Page 32: ...32 2008 2009 Graphic Products Inc All Rights V1 0 6 9 09...
