GRANULDISK Granule Maxi, Service Manual, Page: 42 / 97

4.4 GD Memo™ 4 Programming
The following menus can be can be scrolled by using eco button (3) or the Normal program
button (5).
1. Language:
Set the languge by pressing Confirm button (1) and set the language by scrolling with
eco (3) and Normal program (5). Press Confirm (1) to select the languge
2. Values on the level sensors:
Values of level sensors are displayed and status on door switches (serial connected i.e.
both have to be closed to give status “Doors closed”).
Values on level sensors should be 0–100 when no level and 4095 when indicating water,
any value above 500 (factory setting)is read as level by the software.
WT=Wash tank
URT=Upper rinse tank
LRT=Lower rinse tank
3. Read operation data:
Here the data from the last 97 programs are stored. see section 4.3.1 Reading data
on the control panel display , on page 36
4. Read accumulated values:
In this menu the number of occurrences of most errors are stored that has occurred
during wash cycles. The total number of cycles and type of cycle can be read out.
5. Steam reduction equipment:
Activate and deactivate steam reduction, if installed.
6. Type of rinse aid dosage
”Per cycle”: Dose when rinse tank is refilled after cycle.
”Per litre”: Dose when rinse tank is filled after cycle and during filling of wash tank.
42 Rev. 2012-05