GRANULDISK Granule Maxi, Service Manual, Page: 34 / 97

4.2 Flashloader 4.2 4 Programming
Example: Basket drive ticked, basket drive out port forced, basket drive motor running.
3. The inputs are displayed in the “InPorts” field on the computer screen.
- time
- temperature settings
- and tank levels (No level<500, Level>500.)
are displayed at the top of the screen.
4. Always finish the session by pushing “Run from machine”. Restart the machine and
make sure it runs.
Tip:When looking at the ticks on “In Ports” always look for changes when the sensor/function
is manipulated. (By hand or using the Out Ports.)
In this mode no information is shown on the machine’s display.
4.2.5 Uploading
NOTE
If the main PCB is replaced all data is lost, if possible read out the values for
Service and Granules before the PCB is exchanged. The values are then
noted and can be entered using Flashloader after the new PCB is installed.
1. Connect the computer by pressing “Autodetect” and then select “Run from Flash”. (if not
done in previous section.)
2. Update date and time in the PC settings by selecting “Set Time”.
NOTE
Check the time and date on the PC. The machine will be set to the time
setting of the PC.
34 Rev. 2012-05