33.
40.
39.
38.
51
FIGURE 61
FIGURE 63
FIGURE 62
FIGURE 64
34.
35.
36.
37.
Install the spline coupling (16) and
O-ring (25). (Figure 61)
Install dowels (20).
Install body (1) with identifying
mark made in Step 2 facing you, and
with gear bore up
.
To assemble this pumping section,
repeat Steps 23 through 31, using
gears 7 and 5.
Install dowels (20) in body (1).
(Figure 62)
Install and tighten stud bolts.
(Figure 63)
If a new flange plate (4) is used,
plug (27) will have to be pressed
into seal drain hole on the dis-
charge side of the flange plate.
(Figure 64)
For seal replacement, refer to seal
assembly section in this manual.
Summary of Contents for LOED 534A
