![background image](http://html1.mh-extra.com/html/graco/probell-electrostatic-controller/probell-electrostatic-controller_instructions-and-parts_2251234061.webp)
Troubleshooting
Error Codes
The Electrostatic Controller is monitored constantly. If a error is detected, an error message is indicated
with a error code.
The error codes are shown in red on the A5 display.
The four most recent error codes are stored by the order of their appearance. Each error in the list must be
acknowledged with the
key. If an error code is shown, the
key cannot be used for other functions
The table below shows all possible error codes for the Electrostatic Controller.
Code
Description
Criteria
Controller
Action
Solution
Electrostatics
H11
Applicator
Failure
The controller does not detect
a current from the applicator, or
detects a current that is too low.
Stop
• Verify applicator power
cable connection, perform
Power Cable Continuity, page 64
, and
replace cable if needed.
• Replace applicator power cable or
applicator power supply if needed.
H12
High Voltage
Overvoltage
Measured voltage output is
greater than 105 kV.
Stop
• Verify system grounding.
• Verify applicator power cable
connection and perform
Power Cable Continuity, page 64
• Replace applicator power cable or
applicator power supply if needed.
H13
Applicator
Supply
Overvoltage
Applicator voltage is too high. Stop
• Verify applicator power
cable connection, perform
Power Cable Continuity, page 64
, and
replace cable if needed.
• Replace applicator power cable or
applicator power supply if needed.
H15
Arc detection
static limit
The static arc detection
threshold is exceeded. A
grounded object came too
close to the applicator.
Stop
• Verify closest distances to parts.
• Verify paint conductivity.
• Verify spraying parameters associated
with static arc detection, see
Run Screen 2 (Arc Limits), page 52
H16
Arc detection
dynamic limit
Dynamic arc detection
threshold exceeded. A
grounded object approached
the applicator at too high of a
speed.
Stop
• Verify fastest approach to parts.
• Verify paint conductivity.
• Verify spraying parameters associated
with dynamic arc detection, see
Run Screen 2 (Arc Limits), page 52
3A3657C
61