Graco LSR Select, Instructions Manual

Page: 14 / 112

Setup
14 3A2152B
5. Install Feed System.
Feed components are purchased separately and not a
part of this system.
Recommended feed parameters:
• Base feed pressure:
Load base pump with 300-800 psi fluid pres-
sure.
• Base fluid hose connection:
1” NPT male.
• Inhibitor/Catalyst/Color feed pressure:
Load 1093's with 200-400 psi fluid pressure.
• Inhibitor/Catalyst/Color hose connection:
JIC(04)
6. Connect the Base Pump to the
Valve Stack.
a. Connect the fluid hose from the outlet of the
base pump to the inlet of the Valve stack.
b. Connect the motor cables in the first conduit to
the matching servo motors on the valve stack.
c. Connect the encoder cables in the second con-
duit to the matching servo motors on the valve
stack.
NOTICE
Use at least 10 layers of PTFE tape and use pipe
dope on the fluid inlet fitting to prevent galling.
F
IG
. 6: 1” NPT Base Inlet Connection
F
IG
. 7: Connection Port
ti18100a
1” Inlet
ti18101a
(Other connec-
tions are found on
other side of
visual)
NOTICE
Use at least 10 layers of PTFE tape and use pipe
dope on the fluid inlet fitting to prevent galling.
F
IG
. 8: Base Outlet to Valve Stack Connection
F
IG
. 9: Electrical Cable Connections
ti18102a
ti18103a
Motor
Cables
Encoder
Cables