Maintenance
24
332230T
Bead Tank Mounting
1. When only one bead tank is being installed, it
should be placed on the side of the frame furthest
from the compressor to best distribute weight.
2. Place bead tank on supporting base with outlet
fittings facing compressor.
3. Place clamping band around tank and secure with
mounting hardware shown below. Tighten until
there is no movement between clamp and bead
tank.
NOTE:
The flats on the clamp are not
intended to touch when hopper bracket is
tightened.
NOTE:
Position handle to best suit filling needs.
Loosen bolt (AA) to help swivel, then retighten.
4. Install 36 in. nylon air line (DD) from top of regulator
to swivel fitting on top of bead hopper. Cut air hose
to desired length. Push air line into fitting until end
touches bottom of fitting.
ti24485a
ti20704a
AA
ti20493a
DD